Caple C995I - Using Your Induction Hob

Instruction manual C995i
16
Please keep this instruction manual for future reference
USING YOUR INDUCTION HOB
TO START COOKING
Touch the ON/OFF control. After power on, the buzzer beeps once, all
displays show “ – “ or “ – – “, indicating that the induction hob has
entered the state of standby mode.
Place a suitable pan on the cooking zone that you wish to use.
Make sure the bottom of the pan and the surface of the cooking zone
are clean and dry.
Touch the heating zone selection control, and the indicator next to the
key will flash.
Select a heat setting by touching the ”-“ or “+”control.
If you don’t choose a heat setting within 1 minute, the induction hob will
automatically switch off. You will need to start again at step 1.
You can modify the heat setting at any time during cooking.
s
n
ce
If the display flashes alternately with the heat setting this means that:
› You have not placed a pan on the correct cooking zone.
› The pan you’re using is not suitable for induction cooking.
› The pan is too small or not properly centred on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone. The display will
automatically turn off after 2 minutes if no suitable pan is placed on it.