Please keep this instruction manual for future reference Instruction manual DD780BK 35
COOKING ZONE TIMER (1-99 MIN.)
When the hob is switched on, an independent timer can be programmed for every cooking zone.
Select a cooking zone, then select the power setting and finally, enter the cooking zone timer
mode by pressing the Timer button twice. Once activated, one of the four red LED’s arranged
around the timer will flash to indicate which zone you are setting the timer for. Use the and
keys to adjust the cooking zone timer, and once set, wait for 5 seconds for the minute minder
to confirm (red LED will stop flashing once set and remain on until the timer elapses).10 seconds
after the last operation, the timer display will change to the timer that will run out next (in cases
where a timer is set on more than one cooking zone).
When the timer has run down, a signal will sound, the timer display will show “00” and the
assigned cooking zone timer LED will blink. The programmed cooking zone will switch off and “H”
will be displayed if the cooking zone is hot.
The sound signal and the blinking of the timer LED will stop automatically after 2 minutes and/or
by pressing any button.
To cancel the cooking zone timers, enter the timer mode for the relevant zone following the
instructions above, and reduce the time remaining to ‘00’.
BUZZER
While the hob is in operation, the following activities will be signalled by the buzzer.
Normal button activation will be accompanied with a short sound signal.
Continuous button operation over a longer period of time (10 seconds) will be accompanied with
a longer, intermittent sound signal.
BOOST FUNCTION
To use this function, select a cooking zone and set the desired power level, then press the “P”
(Boost) button.
The Boost function can only be activated if it is applicable with the cooking zone selected. If the
Boost Function is active, a “P” is shown on the corresponding display.
Activating the booster can exceed the maximum power, in which case the integrated power
management will be activated.
The necessary power reduction is shown by the corresponding cooking zone display blinking.
Blinking will be active for 3 seconds to allow for further adaptations of the settings before
power reduction.
To Next Page
Loading...
