12 Instruction manual Oi363 Please keep this instruction manual for future reference
DUCTED VERSION
› Place the top fixing bracket (Fig.5.1) on the ceiling. Drill 4 holes, 8mm each, next to
the slots.
› Insert the plastic dowels into the holes (Fig.5.1A) and screw the top fixing bracket to the
ceiling (Fig.5.1B).
› Fasten the lower structure (Fig.7.2) to the hood by making sure its holes and the
metric-thread screws welded on the fan support coincide (Fig.7.1).
› Insert the washers and nuts provided and screw with an appropriate tool.
› Connect the ducting to the power unit ducting spigot and fix securely with a hose clamp.
› Insert the upper structure (Fig.7.3) into the lower structure and adjust its height as required
by matching it with the hob’s minimum height.
› Tighten the two structures securely with the screws provided (Fig.7.3B).
› Insert the two extension tubes from above (Fig.7.4 slots into Fig.7.5), adjust the two
structures to get them to the appropriate level. Lift the hood together with the structure
and the chimney sections to make the four springs (Fig.7.6) hook to the slots (Fig.7.3C).
› Then tighten the two elements securely (Fig.6.1 & Fig.6.2) with the safety screws (Fig.6.2A)
and connect the ducting to the underside of the top fixing bracket (Fig.6.2B).
› Make the electrical connections.
› Lift the upper tube (Fig.7.5) up to the ceiling and insert the two self-tapping screws
(Fig.7.5D).
To Next Page
Loading...
