Need help?Do you have a question about the Caple INCH and is the answer not in the manual?
Appliance must only be used for its intended purpose; incorrect use can lead to danger and liability issues.
Only plug into earthed outlet; connect to mains by a competent, qualified electrician following regulations.
Installation must be strictly followed; failure to comply can result in overheating and serious damage.
Secure brackets to the top of extractor using provided screws; check adjustment screw is fitted.
Hook extractor bracket onto wall bracket; adjust forward/backward and height using screws.
Supply cable should be shielded from grill/hob/oven; heat can damage insulation and cause fire risk.
Exposed power supply cable should not come within 70cm of a direct heat source; channel into wall.
Do not prepare flambé dishes under extractor; take care with frying oil to prevent fires.
Periodically clean grease filter panels in warm soapy water or dishwasher; check for discoloration.
Connect appliance to exhaust duct and vent to outside atmosphere via exterior wall using 150mm diameter ducting.
Ensure ducting is short with minimum bends; do not discharge air into flues used by other appliances.
Adapt extractor to clean air using a charcoal filter (code: CAP73CF); replacements available online.
Instructions for changing extraction outlet from top to rear by removing and rotating transfer box.
Ensure electricity supply is switched off before connecting; use a double pole switched fused spur outlet.
Recommend connection by a qualified electrician who complies with I.E.E and local regulations.
Appliance has Class 2 insulation; neither wire should be connected to the terminal marked 'E' or earth symbol.
Check plug, supply, fuse, or grease accumulation; contact Caple Service for persistent faults.
Appliance must only be used for its intended purpose; incorrect use can lead to danger and liability issues.
Only plug into earthed outlet; connect to mains by a competent, qualified electrician following regulations.
Installation must be strictly followed; failure to comply can result in overheating and serious damage.
Secure brackets to the top of extractor using provided screws; check adjustment screw is fitted.
Hook extractor bracket onto wall bracket; adjust forward/backward and height using screws.
Supply cable should be shielded from grill/hob/oven; heat can damage insulation and cause fire risk.
Exposed power supply cable should not come within 70cm of a direct heat source; channel into wall.
Do not prepare flambé dishes under extractor; take care with frying oil to prevent fires.
Periodically clean grease filter panels in warm soapy water or dishwasher; check for discoloration.
Connect appliance to exhaust duct and vent to outside atmosphere via exterior wall using 150mm diameter ducting.
Ensure ducting is short with minimum bends; do not discharge air into flues used by other appliances.
Adapt extractor to clean air using a charcoal filter (code: CAP73CF); replacements available online.
Instructions for changing extraction outlet from top to rear by removing and rotating transfer box.
Ensure electricity supply is switched off before connecting; use a double pole switched fused spur outlet.
Recommend connection by a qualified electrician who complies with I.E.E and local regulations.
Appliance has Class 2 insulation; neither wire should be connected to the terminal marked 'E' or earth symbol.
Check plug, supply, fuse, or grease accumulation; contact Caple Service for persistent faults.
General| Brand | Caple |
|---|---|
| Model | INCH |
| Category | Ventilation Hood |
| Control Type | Touch |
| Number of speeds | 3 |
| Lighting type | LED |
| Number of Motors | 1 |
| Grease filter type | Aluminium |
| Lighting | LED |
To Next Page
