Instruction manual INCH
Please keep this instruction manual for future reference
20
TROUBLESHOOTING
Troubles Reason / Solution
Light bulb doesn’t
come on
A replacement may be necessary, but first check the extractor is connected
to the power supply and switched on. If a replacement is needed
remember to disconnect power supply before removing the bulb.
The motor is on
but fan doesn’t
seem to be as
efficient as usual
Check grease filter, if it has not been cleaned recently, it might be clogged
with grease. If filter is relatively clean, check charcoal filters. If this has not
been replaced for more than six months. Remove and insert new a one.
As charcoal filters clog in just the same way as the grease filter, thereby
reducing the efficiency of both the fan and the filter itself.
Works normally
but cooking smells
linger
If you’re using the unit in re-circulation mode, change charcoal filter. It
may be past its prime. Also ensure you switch the extractor on 15 minutes
before cooking and leave it running for at least 15 minutes after you
finish. This will help clear the cooking odours more efficiently.
Controls fail to
switch motor on
Check plug/electrical supply, socket and fuse. If these are in order and
fault persists, it could be that an accumulation of grease has impaired
the efficiency of the switch mechanism. Try rapidly moving switch on and
off several times in succession to clear grease deposit. If fault continues,
contact Caple service on 0117 938 7420 or email service@caple.co.uk.
Appliance does
not work at all
Check your extractor is switched on at the mains. Next, check for an
unexpected power outage by switching on adjacent lights etc. If all is in
order, contact Caple Service on 0117 9387420 or email service@caple.
co.uk.
Still not working?
Call the service
agent
If, having consulted the above diagnostic chart you are still unable to
remedy the situation, please call Caple service on 0117 938 7420 or email
service@caple.co.uk.
INCH Instruction manual.indd 20 06/07/2017 14:45
To Next Page
Loading...
