29Instruction manual WDi3301Please keep this instruction manual for future reference
QUICK USER GUIDE
CAUTION:
> Detergent only needs to be added in "case I “after selecting pre-washing.
CAUTION:
› Before washing, please make sure the machine is installed properly.
CALIBRATION
It is recommended to calibrate the washer dryer before its first use.
Complete the calibration by following the below steps:
› Power on the washer dryer.
› Press SPEED and DELAY buttons at the same time. “T19” will show on the display.
› Press START/PAUSE, to start the washer dryer and wait until “****” appears.
› The washer dryer is now ready to use.
CAUTION:
> Detergent only needs to be added in "case I “after selecting pre-washing.
CAUTION:
Before using for the first time, the washer dryer should be operated once without clothes, as
detailed below:
› Install the washer dryer
› Open the door and load the laundry
› Measure out the detergent
› Close the door
› Put down (hang up) the drain hose (if not
connected to sink plumbing)
› Turn on the water tap (if not connected to
mains water supply)
› Plug in the power supply
› Turn the washer dryer on
› Select the desired programme and function
› Press the START/PAUSE button to start
washing/drying
NOTE:
Should power go out when the washer dryer is running, a special memory saves the settings
and, when power returns, the machine resumes the cycle from where it left off.
› At the end of the programme, the washer dryer will make a sound to signify the end of the
cycle. END will show on the display
› Close the water tap
› Turn off the washer dryer
To Next Page
Loading...
