Caple WI6136 - Operation and Controls; Operating Your Wine Cabinet

11Instruction manual Wi6135 Wi6135GM Wi6136Please keep this instruction manual for future reference
OPERATING YOUR WINE CABINET
Please use the cabinet within ambient temperatures between 16-32ºC, if the ambient
temperature is higher or lower than this, it will cause the temperature to fluctuate in the
cabinet, possibly preventing it from reaching 5-18ºC.
SETTING THE TEMPERATURE
The temperature setting is range as below:
Upper compartment: 5 - 10ºC
Lower compartment: 10 - 18ºC
› When the system enters the temperature set up. With each press on the
key, the
temperature setting of the upper zone will decrease by 1 ºC. When the temperature setting
reaches the lower limit of 5ºC, the temperature will return to 10ºC. Each press on the
and the temperature setting of the lower zone will decrease by 1ºC. When the temperature
setting reaches the lower limit 10ºC, the temperature will return to 18ºC.
› If you wish to view the actual temperature inside the wine cabinet. Please press the or
key and hold for 3-5 seconds. The actual temperature of the upper zone or the lower
zone will be displayed on the control board. After 5 seconds the temperature will return to
display the set temperature.
› Flashing LED = Cabinet Temperature
› Steady LED = Set Temperature
NOTE:
If the unit is unplugged, power lost or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the wine cabinet will
not start.
When you use the wine cabinet for the first time or you restart the cabinet after having been
shut off for a long time, there could be a few degrees variance between the temperature you
select and the one indicated on the LED readout. This is normal and it is due to the length of
the activation time. Once the wine cabinet has been running for a few hours everything will be
back to normal.