36 Instruction manual WMi3001 & WMi3006 Please keep this instruction manual for future reference
FILTER CLEANING
WARNING
› Be careful of hot water.
› Allow detergent solution to cool down.
› Unplug the machine to avoid electrical shock.
› The filter must be cleaned periodically to ensure the normal operation of the washing
machine.
The washing machine comes with a special filter able to trap large residue, such as buttons or
coins which could clog the drain.
To clean the filter, proceed as follows:
› Ensure all the water has been emptied from the drum.
› Remove the plinth.
› Before unscrewing the filter, we recommend you place an absorbent cloth under it to keep
the floor dry. A small amount of water will come out of the filter as you remove it
- this is normal.
› Turn the filter counter-clockwise to the stop limit.
› Remove and clean the filter; when finished, replace it turning it clockwise. The filter handle
will be locked when it is not possible to turn any further and the handle is horizontal.
Applying a small amount of liquid soap on the filter seal will help refitting.
› Repeat the previous steps in reverse order to reassemble all parts.
29
TDI4000 Instruction Manual Intergrated Tumble Dryer.indd 29TDI4000 Instruction Manual Intergrated Tumble Dryer.indd 29 07/04/2020 10:3107/04/2020 10:31
› Remove and clean the filter; when finished, replace it turning it clockwise. The filter handle will
be locked when it is not possible to turn any further and the handle is horizontal. Applying a small
amount of liquid soap on the filter seal will help refitting.
› Repeat the previous steps in reverse order to reassemble all parts.
WARNING:
The filter must be cleaned periodically to ensure the normal operation of the washing machine.
When the appliance is in use and depending on the programme selected, there could be hot
water in the filter. Never remove the filter during a wash cycle. Always wait until the appliance
has finished the cycle and is empty. When replacing the cover ensure it is securely tightened.
SUGGESTIONS FOR MOVING OR PROLONGED DISUSE
Should the washer dryer be stored in an unheated room for a long period of time, drain all
water from tubes.
Unplug the washer dryer.
Detach the tube from the drainage system and clip on the rear of the machine and lower it,
fully draining water into a bowl.
Secure the drain tube with the drainage system and clip on the rear of the machine
when finished.
Keep the door glass and gasket clean.
The manufacturers warranty only covers faults within the product of a mechanical or electrical
nature. Faults caused by handling, installation or misuse are not covered and may incur a
charge for any repair visit to resolve.
To Next Page
Loading...
