The document is an instruction manual for Caple Wall Chimney Hoods, models ZC622 and ZC922.
Function Description
The Caple extractor hood is designed to extract unpleasant odours from the kitchen. It is not intended to extract steam. The cooker hood uses high-quality materials and features a streamlined design. It is equipped with an electric motor and a centrifugal fan, providing strong extraction with low noise. The hood also includes non-stick grease filters and is designed for easy installation.
The extractor hood can operate in two modes:
- Ducted Mode: In this mode, the cooker hood is connected to an outlet to the outside via an extraction duct with an interior diameter of 150mm. This exhausts fumes and odours directly out of the building.
- Recirculation Mode: If an outside outlet is not available, the exhaust pipe is not required, and activated charcoal filters must be installed. In this mode, the air is filtered through the charcoal filters to trap odours and then recirculated back into the kitchen.
The hood features a touch control panel for operation.
Important Technical Specifications
- Models: ZC622, ZC922
- Extraction Duct Diameter (Ducted Mode): 150mm
- Minimum Distance Above Hob: 65cm to 76cm. For gas hobs, the minimum distance is at least 760mm, or as specified by the hob manufacturer if different.
- Negative Pressure Limit (when operating simultaneously with other fuel-burning appliances): Must not exceed 4 Pa (4×10⁻⁵ Bar).
- Charcoal Filter Type: CAP61CF (for recirculation mode)
- Light Type: LED panel
- Dimensions (ZC622 / ZC922):
- Height: 548 - 1000mm
- Width: 600mm (ZC622) / 900mm (ZC922)
- Depth: 500mm
- Chimney Width: 320mm
- Chimney Depth: 280mm
- Base Thickness: 60mm
Usage Features
- Touch Control Panel: The hood is operated via a touch control interface.
- ON/OFF Button: Press and hold for 2-3 seconds to turn the extractor fan on. Press again to switch off.
- Speed Settings:
- LOW SPEED BUTTON (1): Suitable for simmering and cooking that does not produce much steam or odour.
- MEDIUM SPEED BUTTON (2): Ideal airflow speed for standard cooking.
- HIGH SPEED BUTTON (3): Used when a high amount of steam or odours are produced, for the most effective extraction.
- LIGHT BUTTON: Switches the LED light on and off. The LED light panel is for illuminating the cooking area only, not for general room illumination.
- Optimal Performance: For best results, it is recommended to switch on the extractor 15 minutes before cooking and leave it running for 15 minutes after cooking. This ensures air circulation before and after cooking.
- Safety:
- The appliance must only be used for its intended purpose.
- Do not use accessories or attachments not recommended by Caple.
- Do not immerse cords or plugs in water or other liquids.
- Never touch the appliance with wet or damp hands.
- Never pull the power cable.
- Do not flambé under the cooker hood.
- Never leave frying pans unattended during use, as overheated fats and oils can catch fire.
- Ensure adequate air supply in the room if a fuel-burning appliance is present.
- Children must not operate the machine or play with the appliance.
- Cleaning and user maintenance must not be performed by children without supervision.
- The appliance is intended for household and similar applications (staff kitchen areas, farmhouses, hotels, motels, residential environments, bed and breakfast environments).
- The power cable, if damaged, must only be replaced by a Caple appointed engineer.
- The appliance must be connected to a properly earthed outlet by a competent person (qualified electrician, member of N.I.C.E.I.C, complying with I.E.E and local regulations).
Maintenance Features
- Regular Cleaning:
- Before cleaning or maintenance, switch off the electricity supply and remove the plug from the wall.
- Use a soft damp cloth with lukewarm, mildly soapy water or household cleaning detergent.
- Do not use metal pads, chemicals, abrasive material, abrasive cleaning creams, or stiff brushes.
- Cleaning the Grease Filter:
- Clean the grease filter every month to minimize fire risk and maintain efficiency.
- Filters can be cleaned with warm water and washing-up liquid, or in a dishwasher (separately from other items to prevent food trapping). Discolouration in the dishwasher is normal and not a fault.
- Replacing the Charcoal Filter (Recirculation Mode Only):
- Charcoal filters trap cooking odours and need regular replacement.
- Recommended replacement frequency: every 6 months, but this can vary depending on usage.
- Replacement filters (CAP61CF) can be purchased from www.caple.co.uk.
- To install: detach the grease filter, fit the activated charcoal filter onto the side of the motor, and turn it clockwise to lock into place. Repeat on the other side. Ensure the filter is securely locked.
- Replacing the LED Panel:
- Lights must be replaced by a qualified person.
- Steps: Switch off and unplug the appliance, unplug the LED lamp cable, unscrew screws and nuts on the 2 brackets, replace the LED panel, screw back onto brackets, plug the LED lamp cable back in.
Environmental Protection
- Waste electrical products should not be disposed of with household waste.
- Recycle where facilities exist; check with local authority or retailer for recycling advice.
- The appliance is marked according to the European directive on Waste Electrical and Electronic Equipment (WEEE).
- Disposal must be carried out in accordance with local environmental regulations.
Warranty and Service
- The appliance is covered by a warranty. Register ownership by completing and returning the guarantee card or online at www.caple.co.uk.
- Keep the warranty card and proof of purchase; failure to show them may result in repair charges.
- Spare parts are available from Caple Service and authorized centres.
- For troubleshooting or spare parts, contact Caple Service at 0117 938 7420 or service@caple.co.uk.
General
To Next Page
