29
Clip for fixing
the cord
Clip for fixing
the cord
Turn over the floor mat place the
power cord to the console box in
between the seats.
Fix the power cord to the console box
using the provided clips and double-stick
tage. This is the last step of installation.
Open the door of the driver’s seat and
push the cord into the opening to the
horizontal direction of the dash board.
If it does not work well, try fixing the
cord with the provided clips and
double-stick tage. (on 1 spot)
Fix the power cord to the bottom
areas
along the door frame.(on 1 spot)
If the power lamp does not turn on,
check if the connection is properly made.
Also, try removing dirt or dusts inside the
cigar socket.
Plug the ciger power plug into the
ciger socket inside the car.
Please do not install the product or adjust volume while driving as it might cause a car accident.
If there is a smoke or strang small coming from the cigar socket, stop using the product
immediately and visit us or ane of our dealers.
Dusts in the cigar socket can cause a heat or fire. Regularly clean the dusts.
Check often if the main body is properly installed. Vibration can lead to disconnection and it might
cause personal injury or damage of the product.
保#We are not liable for any kind of accidents occurred by the customers will be their sole
responsibility.
Start the engine and if the power lamp
on the left side of the main body turns
on, installation is completed.
䂈☐GḔ㥉㟝G
䆨⫱
987
5 6
Check installation
Safety Precautions (保# Please pay particulat attention)
To Next Page
Loading...