Car and Driver CDC-646 - 2.3 Powering the Dash Cam On and Off; 2.4 Date and Time Setting

7
To remove the memor y card, press down on the exposed
edge of the memory card until you hear or feel a click.
Remove your finger and the card will pop out and away
from the device. You can then easily remove it from the
Dash Cam.
Powering the Dash Cam On and Off
Once the vehicle engine is started, the Dash Cam
automatically turns on and begins recording.
When you shut your car off, the Dash Cam automatically
saves the current recording and turns off 5 seconds later.
To manually turn on the power, press the Power/OK
button. To turn it off, press and hold the Power/OK button
for 2 seconds.
Date and Time Setting
While video is not being recorded, press the
Menu/Mode button to enter the Settings menu and
using the Up and Down buttons navigate to General
Settings then Date and Time. Press the Power/OK
NOTE:
• Do not remove or insert the memory card when the device
is powered on. This may damage the memory card.
• It is recommended to use up to a 128 GB, Class 10 speed or
above memory card.
• It is recommended to format the memory card before initial
use.
NOTE:
On some vehicles, the power socket will continue providing
power after the engine is turned off. If this is the case, to avoid
draining your car battery, please manually unplug the Dash Cam
when the engine is turned off.