✄
Supply of Machinery (Safety) Regulations 1992
EC Declaration of Incorporation
Powered Garage Door Operators
The powered garage door operator models listed below are intended to be incorporated
with a suitably designed garage door (see matrix below) to provide powered operation.
Samples of powered door operators of the above types have been tested/checked and found to
conform with the provisions of the Machinery Directive (98/37/EC), the Low Voltage Directive
(73/23/EEC) and the E.M.C. Directive (89/336/EEC).
A powered door operator must not be put into service until it has been completely and safely
assembled and installed, with an appropriate type, size and weight door, in accordance with the
door and operator manufacturer’s fitting instructions, using a suitable connection arm and
appropriate safety devices, etc; and not until the complete installation has been declared to be
in conformity with the provisions of the Machinery Directive.
The technical files for the operators listed above are held by Cardale Doors Ltd. and will be
made available for inspection by an enforcing authority, should the need arise:-
Being the responsible person appointed by the manufacturer and employed by:
Cardale Doors Ltd. Registered Office: Arundel House, Arundel Road, Luton, Bedfordshire. LU4 8DY
Registered No. 926537 (England)
This Declaration is made by:
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
C. Parkman, Operations Director
Figures refer to maximum aperture width (mm), maximum aperture height (mm) and maximum door weight (kg) respectively.
Operator suitability
Door type DC-650N DC-650N DC-800N DC800N
(standard boom) (extended boom) (standard boom) (extended boom)
Slide away 5030/2410/85 5030/2630/85 5182/2410/100 5182/2630/100
Sectional 5030/2160/85 5030/2410/85 5182/2160/100 5182/2410/100
(with torsion spring)
To Next Page
