To Next PageTo Next Page
Need help?Do you have a question about the Cardale DC-800 and is the answer not in the manual?
Door reverses within 2 seconds if obstructed during closing.
Closing door reverses if not fully closed within 88 seconds.
Opening door stops immediately if obstructed.
Recommends Beam Break for additional safety against obstructions.
Identify door type to follow specific installation instructions.
Specific installation steps for 1-piece up-and-over garage doors.
Specific installation steps for sectional garage doors.
Explains the meaning of the 8 LED icons on the control panel.
Describes the function of the three program buttons.
Defines LED states (off, illuminated, blinking) and button actions.
How to use buttons to navigate menus and make adjustments.
Lists the available programming menus for basic settings.
Configure door open/close positions and maximum opening/closing forces.
Code the internal transmitter to the operator.
Details external connections, wiring diagram, and component list.
How to connect wall controls and their functions.
Transfer coding from an existing transmitter to a new one.
Recode the system if a transmitter is lost.
Lists common faults, their causes, and solutions.
Error codes indicated by LED flashing patterns.
Lists advanced features like automatic closing and learned force.
Configure the automatic closing timer function.
Adjust the warning phase duration for automatic closing.
Configure the start-up warning duration.
Define behavior after beam break detection during closing.
Lists menus for limiting learned force settings.
Configure how long the operator light stays on.
Adjust the automatic learned force limitation.
Lists menus for controlling external lights.
Set the maximum travel time for security cut-out.
Configure signal light function (illumination or blinking).
Program operator light behavior during warning phase.
Configure external light relay for lighting or alarm signals.
Overview of basic programming menus and functions.
Overview of advanced programming menus for Level 3.
Overview of advanced programming menus for Level 4.
Overview of advanced programming menus for Level 5.
Details connected loads, door travel speed, forces, and lighting.
Guidelines for first use, checks, and routine maintenance.
Contact information for the main distributor.
Table showing operator suitability for different door types.
Outlines installer responsibilities for safety and conformity.
General| Brand | Cardale |
|---|---|
| Model | DC-800 |
| Category | Garage Door Opener |
| Language | English |
