1. ASSEMBLY INSTRUCTIONS – DUAL MOTOR
a) Remove all packaging from the chair base unit and backrest. Carefully unpack
all other items and ensure all parts are there.
b) If castors are required: two lockable castors (for rear of chair) and two normal
castors (for front of chair) are provided. Remove from packaging. Unscrew the lock-
ing nut from the top of the castor and feed through the designated hole on the under-
side of the chair. Re-apply the locking nut and fasten securely
e) Seal fabric from the bottom of the
backrest to the base of the chair
using the Velcro strips.
f) Move the chair in the desired position within the room (see section on
‘Positioning Your Chair’) then put your feet up, relax and enjoy!
d) Check that the handset is plugged into
the motor. If not, connect as per diagram
below.
Locking
castors on
rear of chair.
To Next Page
Loading...