f) Seal fabric from the bottom of the
backrest to the base of the chair
using the Velcro strips.
g) Move the chair in the desired position within the room (see section on
‘Positioning Your Chair’) then put your feet up, relax and enjoy!
2. REMOTE CONTROL – SINGLE MOTOR HANDSET
There are various types of hand controls depending upon the model of chair you
have chosen. Before using the controls please read this important information.
e) At the rear of the chair, connect the base and backrest heat and massage
functions together by connecting the internal wires (these wires will be loosely
protruding from the bottom of the backrest and will be at the rear of the base).
1. Small Black: Power
2. Red: Heat
3. White: Massage
4. Large Black: Heat & Massage Handset
Cable Functions
1.
2.
3.
4.
d) Check that the handset is
plugged into the motor. If not,
connect as per diagram to
the left.
To Next Page
Loading...