www.careco.co.uk CareCo, 1 Turing Court, Great Notley, Braintree, Essex, CM77 7AT
Zoom Mobility Scooter - MS01010014
16
Cleaning the battery
If the battery is contaminated by water, battery acid, dust or other substances, it will discharge quickly. The
battery supplied with the CareCo scooter is sealed and is maintenance free with no risk of battery leakage.
Please follow the steps below to clean the battery.
1. Turn the scooter power switch to ‘OFF’.
2. Remove the seat and dust cover.
3. Remove the shroud and unplug the terminal of the tail-light and signal lights.
4. Use a clean cloth to wipe off the soiled area.
5. Take out the battery.
6. Clean the battery with a clean cloth. If the terminal is covered by white powder, please wipe it clean using warm
water.
Warning
1. The wiring system and charger are placed correctly in the battery pack during assembly by the manufacturer.
Do not attempt to re-locate the wiring system by yourself. The improper layout of wiring system may result
in the wires pinched by battery box, which could result in an electronic system failure.
2. Be sure the battery wires are connected to their correct battery terminal.
Suggestion
If necessary, ask for help from CareCo for advice about maintaining and replacing the battery. Contact Customer
Services on 0845 611 8022 or email: cs@careco.co.uk
Suggestion
1. Make sure the terminals are installed properly and replace the cover.
2. Do not use the battery to charge telecom equipment or other items.
3. Battery efficiency will vary with outside conditions; the driving distances will be shorter in the winter.
If the vehicle is not used for a long time, please charge the batteries at least once a week.
4. Replace both batteries together.
To Next Page