Carel Large ROL 160-1K2 - Alarm Enabled

51
ENG
Control
WTS LARGE +0300131IT rel. 1.0 - 05.09.2022
11.6.12 Conguration of the alarm
output relay
(See 11.7 wiring diagram)
12 ALARM
13 RESET

12A ALARM
ENABLED
» Press the arrow keys éê to to turn the alarm
output on or off.
» Confirm the selection with
 .
The program jumps to submenu "12B".
12B OUTPUT ALARM
CONTACT N.C.
» Press the arrow keys éê to set the switching
direction.
» Default value: NC
N.O. CONTACT = The input functions as a normally open
contact.
N.C. CONTACT = The input works as a normally closed
contact.
» Confirm the selection with éê .
The program jumps back to the main menu.
11.6.13 Operating and service
hour counter
The operating hours counter always runs when
the system is in production mode. It is for general
information and has no further control function.
It counts down the time. As soon as the counter has
reached "0 hours", the following message appears
on the display: "EXECUTE MAINTENANCE" (do
maintenance).
The counter is set in the " 18 MAINTENANCE" submenu.
13 RESET
14 SYSTEM TEST

13A RES HR COUNT
ENTER = YES
» Press the arrow keys éê to select, if the
operation counter should be reset.
» Confirm the selection with
 .
The program jumps to submenu "13B".
13B RES SERVICE
ENTER = YES
By pressing the arrow keys éê you select if the service
interval should be reseted.
» Confirm the selection with
 .
The program jumps back to the main menu.
Resetting the parameters to factory settings
(except password):
» Switch off the system
» Press and hold é and è and switch on the
system. Only then release the buttons.
RESET Password:
» Switch off the system
» Press and hold é and ESC and switch on the
system. Only then release the buttons.