4
“Power+” +0500120IE - rel 1.1 - 02.05.2017
ENG
Note:
This instruction sheet is provided for the purpose of describing the operations for commissioning and installing
the drive, as well as illustrating the main features of the product. For further information, see the user manual code
+0300093EN, downloadable, including prior to purchase, from www.carel.com, under “Literature”.
The Power+ drives are compliant with:
• Low voltage directive 2014/35/EU;
• Electromagnetic compatibility directive 2014/30/EU.
NO POWER
& SIGNAL
CABLES
TOGETHER
READ CAREFULLY IN THE TEXT!
WARNINGS: Separate as much as possible the probe and digital input signal cables from
the cables carrying inductive loads and power cables to avoid possible electromagnetic
disturbance. Never run power cables (including the electrical panel wiring) and signal
cables in the same conduits.
Symbols:
Dangerous voltage
Caution, hot surface
Important: brings critical subjects regarding use of the product to the user’s
attention
Note: when attention must be given to subjects of relevant importance,
in particular regarding practical use of the various product functionalities.
WARNINGS
This product is to be integrated and/or incorporated into the nal apparatus or equipment.
Verication of conformity to the laws and technical standards in force in the country where
the nal apparatus or equipment will be operated is the manufacturer’s responsibility.
Before delivering the product, Carel has already completed the checks and tests required
by the relevant European directives and harmonised standards, using a typical test setup,
which however cannot be considered as representing all possible conditions of the nal
installation.
To Next Page
Loading...
Need help?
General
