Need help?Do you have a question about the Carel Power+ PSD1024400 and is the answer not in the manual?
General| Input Current | 24 A |
|---|---|
| Frequency | 50/60 Hz |
| Efficiency | 98% |
| Protection Degree | IP20 |
| Cooling Method | Forced air |
| Input Voltage | 380-480V AC |
| Output Voltage | 0-480V AC |
| Operating Temperature | -10°C to +50°C |
| Humidity | 5-95% (non-condensing) |
Instructions for qualified personnel and system installation compliance with standards.
Critical safety rules for operating the drive, including voltage checks and maintenance.
Critical safety measures before performing electrical work on the drive.
Instructions for power supply connection, grounding, and cable selection for optimal performance.
Connecting the 'Safe Torque Off' input for safety or to the auxiliary 24 Vdc supply.
Wiring diagram for single-phase Power+ drives, showing power, control, and communication connections.
Wiring diagram for three-phase Power+ drives, including power, control, and communication connections.
Table of rated values, cable cross-sections, maximum lengths, and fuse specifications.
To Next Page
