Need help?Do you have a question about the Carel Power + PSD1 Series and is the answer not in the manual?
General| Manufacturer | Carel |
|---|---|
| Category | Inverter |
| Protection Degree | IP20 |
| Output Voltage | 3-phase 0 to input voltage |
| Control Method | Sensorless vector control (SVC) / V/f control |
| Communication Interfaces | Modbus RTU |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overheat, Short circuit |
| Operating Temperature | -10°C to +50°C |
| Braking Chopper | Built-in (for some models) |
| Cooling Method | Forced air cooling |
Provides essential general safety precautions and installation guidelines for the Power+ drive.
Outlines critical safety procedures and rules to follow during operation and maintenance of the drive.
Details the key functionalities, operational capabilities, and main features of the Power+ drive.
Lists the available Power+ drive models, their specifications, and frame sizes for easy selection.
Describes optional accessories available for the Power+ drive, such as DC chokes.
Explains how to identify the Power+ drive using its rating plate, including code and serial number.
Illustrates the physical structure of the Power+ drive, identifying key components and terminal blocks.
Provides detailed physical dimensions for the Power+ drive, varying by cooling system and assembly type.
Guides the user on drilling procedures and mounting methods for panel and external heat sink installations.
Details cooling requirements and fan operation for Power+ drives, emphasizing airflow and heat dissipation.
Covers essential safety precautions and procedures for performing electrical installation of the Power+ drive.
References guidelines for EMC compliance, directing users to relevant sections and manuals for detailed information.
Provides detailed instructions and warnings for making power and signal connections to the Power+ drive.
Presents a wiring diagram for single-phase Power+ models, illustrating connections for power, control, and communication.
Shows the wiring diagram for three-phase Power+ models, detailing power, control, and communication connections.
Describes the specific features and assembly of Power+ models designed with coldplate cooling systems.
Explains the use and connection of the optional EMI filter for reducing emissions to comply with EN61800-3 category C1.
Details the optional DC choke for three-phase drives, used to reduce harmonic currents per EN61000-3-12.
Lists essential checks to perform on the drive and motor before initial startup to ensure correct operation.
Outlines the required routine maintenance tasks to keep the Power+ drive operating optimally and safely.
Provides a table of rated input/output values, cable sizing specifications, and fuse recommendations for Power+ drives.
To Next Page
