Carel pRack pR300 - 1. INTRODUCTION; 2. COMPATIBILITY TABLE

5
+030220735 - 1.0 - 19.05.2016
ENG
1. INTRODUCTION
2. COMPATIBILITY TABLE
As regards the pRack software versions and EVD EVO driver versions, not all combinations are possible. The
table below shows compatibility between the different versions. This should be referred to in particular
when upgrading the pRack software or replacing the EVD EVO driver.
pRack Model pRack SW Version Driver EVD Version Compatibility
pR300T
<= 3.1
5.0 / 5.1
ü
5.6 / 5.7
û
>= 3.2
5.0 / 5.1
ü
5.6 / 5.7
ü
pR100T
<= 3.1
5.0 / 5.1
ü
5.6 / 5.7
û
>= 3.2
5.0 / 5.1
ü
5.6 / 5.7
ü
pR300
< 3.2.0
5.0 / 5.1
ü
5.6 / 5.7
ü
>= 3.2.0
5.0 / 5.1
û
5.6 / 5.7
ü
Tab. 2.a
The pRack pR300 and pR300T controllers benefit from the use of the EVD EVO driver to both control
motorised valves and as an input and output expansion.
The driver is configured using the pRack screens and consequently does not need to be fitted with a display.
Nonetheless, this is recommended in order to constantly monitor information on valve opening.
The purpose of this guide is to illustrate the recommended procedure for installing or replacing an EVD EVO
driver on the Fieldbus port.