Appendix
Flash Kit Contents:
Product # Quantity Description
67x100 1 Fuselage (nosegear door taped to fuselage)
67x201 1 Wing (with servo covers/LG doors)
670106 1 Fuel tank, fibreglass (for fuselage)
67x101 1 Canopy frame (with fixings completed)
670102 1 Exhaust nozzle (fibreglass)
67x104 1 Clear Canopy
67x301 1 Stabiliser assembly (with servo covers taped on)
xxxxxx 1 Plastic fairing for Rudder Linkage (painted)
xxxxxx 2 Plastic fairings for Stab Linkages (painted)
910510 1 Entry cone/Bellmouth for thrust tube (carbon)
670107 1 Inlet duct joiner (Fibreglass)
670108 1 Bypass ducting (carbon), top and bottom halves
670111 1 Cockpit tub - 4 pieces (moulded plastic, white)
67x204 1 pair Leg Covers, painted, (left and right)
670101 1 Exhaust ducting (inner and outer tube)
xxxxxx 1 Fuel system hardware pack
670109 1 Hardware pack
xxxxxx 1 Instruction Manual and photosheets (English)
670110 2 Wing and Stab Protection bags
Hardware bag:
Fuselage pack
Quantity Description
1 Plastic Hinge, Flat, 25mm wide. (nosedoor fixing)
2 Aluminium angles, 12 x 12 x 10mm approx. (carbon cone fixing)
4 Sheet metal screw, 2.9Ø x 10 mm (fixing carbon cone & outer thrust tube)
4 Sheetmetal screw, 2.9Ø x 10mm (fixing carbon cone to inner thrust tube)
4 Allen bolt, M3 x 12mm (Rx & ECU plate fixing)
4 T-nut, M3 (Rx & ECU plate fixing)
4 Washer, M3 (Rx & ECU plate fixing)
4 T-nut, M4 (turbine mounting)
4 Allen bolt, M4 x 20mm (turbine mounting)
8 Washer, M4 (turbine mounting & alignment)
4 T-nut, M4 (nose retract fixing)
4 Allen Bolt, M4 x 16mm (nose retract fixing)
3 Sheetmetal screw 2.2Ø x 10mm (nosedoor fixing)
1 Hinge wire, 2mm Ø, 500mm long (canopy fixing)
1 Ball-link, plastic, M2 (canopy fixing)
1 3mm thick balsa/ 200g fibreglass sheet 200 x 160mm (Fuel tank base)
1 Velcro band, double-sided 18mm wide, 1.5 metres (Equipment installation)
1 Fibreglass cloth, 160 gram, 200 x 200 mm (Fuel tank base)
2 Sheetmetal screws, 2.9Ø x 10mm (Exhaust nozzle fixing)
4 Crimp tubes, inside diameter 2mm (nosegear steering)
1 Steel pull-pull cable 0.8mm x 1000mm (nosegear steering)
2 M3 clevise, steel (nosegear steering)
2 Nut M3 (nosegear steering)
32
To Next Page
Loading...
