LB.00068.20 Pagina 33
WASHING
1) Washing the group and filter holder.
It is advisable to carry out these types of washing at the end of each working day.
1a) washing the filter holders.
Carry out the following operations:
Remove the filters from the filter holders and wash both parts under running water.
Remove the remaining coffee using a cloth.
If the filters get clogged up and you cannot manage to clean them by washing, it is advisable to place it under a naked flame to burn any
coffee particles remaining in the holes.
This operation should not be carried out frequently, as it may damage the filter.
1b) washing the group gasket.
Carry out the following operations:
Insert the blind filter membrane supplied in the filter holder.
- Turn the machine ON;
- While keeping the key N. 5 pressed, press the key N. 1 of the group you want to clean. The group will dispense at pulses for a total
duration of 100 seconds;
- Slightly open and close the filter holder a few times, letting the water flow out. Be careful not to let hands and other parts of the body
come into contact with water, in order to avoid danger of burns;
- If necessary repeat this operation several times, and remove the remaining coffee from the group gasket using a cloth.
1c) washing the third duct of the group.
Carry out the following operations:
- Insert the blind filter membrane supplied in the filter holder;
- Turn the machine Off;
- While keeping the key N. 5, press the key N. 1 of the group you want to clean. The group will dispense at pulses for ten times for a
total duration of 100 seconds.
PROGRAMMING
1) Programming the coffee dose . ( For E models ).
The following procedure is valid for all coffee keys.
- Press key N°5 ( contin./ progr.) and keep it pressed for five seconds. The programming level is shown by the flashing light on the
keys N°5 ( contin./ progr.).
- press the coffee dose key to be programmed and the beverage will start being dispensed;
- press the selected dose key again when the required dose has been delivered. The dose will be stored in memory automatically.
The procedure is separate for each group.
2) Programming (continuous / program.) key No. 5 ( For E2-3-4 models ).
This function will activate or deactivate key No. 5 (continuous/program.) to deliver continuously or in doses.
Proceed as follows:
- cut off the power supply to the machine.
- turn the machine on by holding down key No. 5 (continuous/program.) until its led comes on.
- cut off the power supply to the machine.
- turn the machine back on, which is now ready to operate.
SPECIAL FUNCTIONS FOR MACHINE CALIBRATION
Only Assistance Service personnel authorised by CARIMALI S.P.A. are permitted to enable the use of these functions.
1) Enabling or disabling key N° 1 of the first group on the left to dispense Tea or Coffee.
Key N° 1 of the first group on the left can be enabled to dispense Coffee (for ECO LUX model machines) or to dispense Tea (for TEMA
model machines).
Proceed as follows:
- cut off the power supply to the machine
- turn the machine on by holding down key No.1 until the led on the keys N°5 ( contin./ progr.) comes on.
- cut off the power supply to the machine
- turn the machine back on, which is now ready to operate.
To Next Page
Loading...
