KEY 1 KEY 2 KEY 3 KEY 4 KEY 5
After the plumbing and electrical connectio
Turn on the tap from the water mains and switch the power ON/OFF by means of main switch.
The display will show for few seconds the software version
This operation will automatically stop when the level of the probe is reached.
Heating the boiler.
Only for Pratica E2 with display, d
uring the heating up phase the display show
up temperature in the boiler is reached.
During this stage, keep the steam tap open for a few seconds, this operation will release the air from the boiler inside.
KEY 1 KEY 2 KEY 3 KEY 4 KEY 5
, proceed to the starting up of the machine.
Turn on the tap from the water mains and switch the power ON/OFF by means of main switch.
The display will show for few seconds the software version
This operation will automatically stop when the level of the probe is reached.
uring the heating up phase the display show
the boiler temperature, this phase will automatically stop
up temperature in the boiler is reached.
During this stage, keep the steam tap open for a few seconds, this operation will release the air from the boiler inside.
the boiler temperature, this phase will automatically stop
During this stage, keep the steam tap open for a few seconds, this operation will release the air from the boiler inside.