Need help?Do you have a question about the Carlos Silva HIDRA CRONO and is the answer not in the manual?
Explains the structure for describing each parameter.
Demonstrates parameter configuration with a specific lift function.
Details the optional PLC feature and its benefits.
Explains the design and operational scope of the PLC software module.
Defines physical, status, temporal, and permanent register inputs.
Defines physical, temporal, permanent register, and lift function outputs.
Details configuration parameters: Type, Input1, Input2, and Out.
Illustrates AND, NAND, OR, NOR, XOR operations with truth tables.
Defines timer behavior based on type: delay, pulse, flashing.
Describes Trigger, Out, and Time parameters for timers.
Details Type, SET, RESET, and Out parameters for flip flops.
Explains how SET and RESET inputs control flip flop output.
Lists physical inputs by name, location, and type.
Lists temporal, permanent registers, and internal status inputs.
Lists physical outputs by name, location, and type.
Lists temporal registers, permanent registers, and lift function outputs.
Configures a logic unit to indicate when the lift is under inspection.
Configures a timer to activate a fan based on car calls.
Uses a flip flop to latch an inverter error signal and a reset button.
Configures logic units to disable floor access based on time and switch.
Defines the connection for the main alarm signal EN81-73.
General| Brand | Carlos Silva |
|---|---|
| Model | HIDRA CRONO |
| Category | Controller |
| Language | English |
To Next Page