14
Remove plug from
collector box.
DO NOT DISCARD.
If alternate vent position
is required, loosen clamp
on inlet of vent elbow.
Remove trap from
collector box.
Attach condensate trap
to collector box with
screw.
Install plug in open
port on collector box.
Slide relief tube in
stand-offs to adjust length.
Vent elbow shown in alternate
orientation. Tighten clamp on
inlet to vent elbow 15 lb.-in.
Align trap over middle and
right-hand port on collector box.
Horizontal Right Trap Configuration
Unconverted Factory Trap Configuration
As Viewed in the Horizontal Right Orientation
A11278
Fig. 9 -- Horizontal Right Trap Configuration
(Appearance May V ary)
59MN7A
To Next Page
Loading...
