Carrier 30RB060-390 - Page 11

11
761.94
30.00[]
2236.08
88.03[]
CG
x
y
CG
2281.37
89.82[]
3587.08
141.22[]
408.89
16.10[]
408.89
16.10[]
246.36
9.70[]
336.50
13.25[]
190.00
7.48[]
200.00
7.87[]
45.00
1.77[]
100.00
3.94[]
RIGGING HOLE
38.00
1.50[]
UNIT MOUNTING2769.30
109.03[]
1447.8[57.0]
39.89
1.570[]
UNIT MOUNTING
2156.30
84.894[]
2X 634.55
24.98[]
391.88
15.43[]
725.63
28.57[]
2X 345.08
13.59[]
315.25
12.41[]
473.75
18.65[]
PIPING ENTRANCE AREA
612.76
24.12[]
218.65
8.61[]
1404.67
55.30[]
1447.80
57.00[]
3257.41
128.24[]
1891.00
74.45[]
2123.60
83.61[]
938.35
36.94[]
215.73
8.49[]
WEIGHT
MCHX
lb/kg
CENTER OF GRAVITY
CGx
MM [INCH]
CGy
MM [INCH]
30RB-110
7133 3236
1759
[69.25]
1064
[41.89]
30RB-100
6769 3071
1676
[65.98]
1067
[42.00]
30RB-090
6555 2974
1689
[66.50]
1088
[42.84]
COOLER LEAVING WATER 6" VICTAULIC
COOLER ENTERING
WATER 6" VICTAULIC
SCROLLING MARQUEE
DISPLAY
CIRCUIT A
COMPRESSORS
CIRCUIT B
COMPRESSORS
HR CONDENSER TUBE SERVICE AREA
COOLER VENT
1/4" NPT
COOLER DRAIN
3/4" NPT
SEE DETAIL
B
CONDENSER DRAIN 3/8" NPT
AIR FLOW
POWER BOX 230V CONTROL/POWER BOX 380V,460V,575V
7/8" KNOCKOUT TO BE USED FOR LOCATING FIELD POWER WIRING
FIELD CONTROL WIRING
FAN ELECTRICAL BOX
(230V ONLY)
(FEB)
BACnet COMMUNICATION OPTION KNOCKOUT FOR 1/2" CONDUIT
COOLER TUBE SERVICE AREA
SERVICE AREA 1219.2[48.0] FROM EACH SIDE OF THE UNIT
DETAIL B SCALE 3:16
22.2[.87]
MOUNTING HOLE
CONDENSER LEAVING WATER 3.0" VICTAULIC
CONDENSER ENTERING
WATER 3.0" VICTAULIC
CONDENSER VENT
1/4" NPT
NOTES:
1. Unit must have clearances as follows:
Top — Do not restrict. Sides and End — 6 (1.8 m) from solid surface.
2. Temperature relief devices located on suction line,
liquid line and filter drier of each circuit and have
1
/
4

flare connection.
3. Dimensions are in mm [inches]. 4. Allow 8 ft (2.4 m) of service access on either side of
unit for condenser coil removal.
a30-4735
LEGEND HR — Heat Reclaim MCHX — Microchannel Condenser Coil
Fig. 7 — 30RB090-110 Air-Cooled Chiller with Heat Reclaim Option Dimensions