Carrier 30RB060-390 - Page 20

20
2281.37
89.82[]
408.89
16.10[]
UNIT MOUNTING2769.30
109.03[]
812.70
32.00[]
UNIT MOUNTING2769.30
109.03[]
408.89
16.10[]
2073.54
81.64[]
7169.08
282.25[]
3208.00
126.30[]
800.00
31.50[]
1781.62
70.14[]
1773.54
69.82[]
755.58
29.75[]
2236.08
88.03[]
934.00
36.77[]
200.00
7.87[]
100.00
3.94[]
y
CG
CG
x
960.40
37.81[]
400.00
15.75[]
240.00
9.45[]
246.36
9.70[]
336.50
13.25[]
39.89
1.57[]
UNIT MOUNTING
2156.30
84.89[]
200.00
7.87[]
200.00
7.87[]
2X 343.58
13.53[]
343.81
13.54[]
553.81
21.80[]
5087.45
200.29[]
3344.54
131.67[]
1892.50
74.51[]
4459.04
175.55[]
601.22
23.67[]
PIPING ENETRANCE AREA
600.00
23.62[]
PIPING ENETRANCE AREA
600.00
23.62[]
PIPING ENETRANCE AREA
600.00
23.62[]
162.77
6.41[]
2X
503.37
19.82[]
2X 769.85
30.31[]
938.35
36.94[]
215.55
8.49[]
WEIGHT
MCHX
lb/kg
CENTER OF GRAVITY
CGx
MM [INCH]
CGy
MM [INCH]
30RB-190,
360A,390A/B
12850
5706
3566
[140.39]
979
[38.54]
CIRCUIT B
COMPRESSORS
SCROLLING MARQUEE
DISPLAY
CIRCUIT A
COMPRESSORS
A
A
HR CONDENSER TUBE SERVICE AREA
COOLER VENT 1/4" NPT
COOLER DRAIN
3/4" NPT
COOLER LEAVING WATER 6" VICTAULIC
COOLER ENTERING WATER 6" VICTAULIC
CONDENSER DRAIN 3/8" NPT
AIR FLOW
FIELD CONTROL WIRING
FAN ELECTRICAL BOX
(FEB)
ALL VOLTAGES
POWER BOX 230V ONLY (CKT A)
7/8" KNOCKOUT TO BE
USED FOR LOCATING FIELD POWER WIRING
(DUAL POINT 230V ONLY)
BACnet COMMUNICATION OPTION KNOCKOUT FOR 1/2" CONDUIT
COOLER TUBE SERVICE AREA
SERVICE AREA 1219.2[48.0] FROM EACH SIDE OF THE UNIT
SEE DETAIL B
VIEW A-A
SCALE 1:32
7/8" KNOCKOUT TO BE
USED FOR LOCATING FIELD POWER WIRING
(DUAL AND SINGLE POINT)
POWER BOX 230V (CKT B) POWER BOX 380V,460V,575V (CKT A,B)
DETAIL B SCALE 1:4
22.2 [.87]
MOUNTING HOLE
CONDENSER ENTERING WATER 5.0" VICTAULIC
CONDENSER LEAVING WATER 5.0" VICTAULIC
CONDENSER VENT 1/4" NPT
NOTES:
1. Unit must have clearances as follows:
Top — Do not restrict. Sides and End — 6 (1.8 m) from solid surface.
2. Temperature relief devices located on suction line, liquid line and filter drier
of each circuit and have
1
/
4
flare connection.
3. Dimensions are in mm [inches]. 4. Allow 8 ft (2.4 m) of service access on either side of unit for condenser coil
removal.
a30-4740
LEGEND HR — Heat Reclaim MCHX — Microchannel Condenser Coil
Fig. 16 — 30RB190 Air-Cooled Chiller with Heat Reclaim Option Dimensions