NOTES:
1. Unit must have clearances as follows:
Top — Do not restrict.
Sides and End — 6(1.8 m) from solid surface.
2. All pumps have drains located at the bottom of
volute for draining.
3. Temperature relief devices located on suction
line, liquid line and filter drier of each circuit and
have
1
/
4
flare connection.
4. Units without a pump package have the same
leaving water connection, Y and Z dimensions
(entering water), and Pump Discharge X dimen-
sions as units with a pump package.
5. Dimensions are in mm [inches].
6. Allow 8 ft (2.4 m) of service access on either
side of unit for condenser coil removal.
a30-4711
MCHX — Microchannel Condenser Coil
Fig. 5 — 30RB090, 100 Air-Cooled Chiller Dimensions
To Next Page
Loading...
