7
Programming the Control
Use this blank grid to write down your required home
temperatures.
You’ll assign time periods to those temperatures later.
Touch ‘N’ Go Option Heat Cool
Home
Away
Sleep
To change the factory settings
Factory defaults for User Conguration
Press and hold the comfort button 1.
(
) to be changed for about ve
seconds. The set temperature along with the symbol
heat (
) or cool ( ) will ash.
Press the up or down button on the right side of 2.
the display until you reach the desired temperature
setting for the current mode of operation. At this
moment the triangle icon (
) above the pressed
comfort button (
) will start ashing.
To change the mode, press the mode (M) button 3.
repeatedly until you see the required mode symbol
ashing on the screen.
Press the up or down button on the right side of 4.
the display until you reach the desired temperature
setting.
Pressing one of the other two Touch 'N' Go button, 5.
item 2 to 4 can be repeated.
Press OK button to conrm changes and exit from the 6.
Comfort change mode.
Procedure for Changing the User Parameter settings to
Default values is given below.
Press simultaneously home ( 1.
) and away ( )
buttons at a time for 10 seconds to enter into the user
conguration mode. When this setting is rst selected,
999 will be displayed in the time display area and an
initial value of 10 will be displayed in the temperature
display area.
Press and hold the down button. When the counter 2.
reaches zero, “Fd” will be displayed in the temperature
display area. This represents factory defaults are in
progress. Upon successful completion of restoring
defaults to EEPROM, the NUI will then force a reset.
English
To Next Page
Loading...
