Carrier 33CS - Device Bus Number 239; Device Element Address; Off

22
Table 4 — Storage Failure (SF) Errors (cont)
LEGEND
ERROR INFORMATION AFFECTED DEFAULT VALUE(S)
SF16
Occupancy Period 8 –
SF17
Schedule Number 0
SF18
Override Time Limit 1
SF28
Fan Operation For Heat ON
SF30
Time Guard Between Modes ON
SF32
LAT Monitoring ON
SF33
First Stage Cooling Temperature Limit 45
SF34
Second Stage Cooling Temperature Limit 50
SF35
First Stage Heating Temperature Limit 110
SF36
Second Stage Heating Temperature Limit 105
SF37
Auxiliary Relay 0
SF38
Optimize Staging ON
SF39
Temperature Lockouts OFF
SF40
Heating Lockout Set Point 60
SF41
Cooling Lockout Set Point 40
SF44
Minimum Heat Run Time 3
SF45
Pre-Occupancy Purge OFF
SF46
Zone Temperature Sensor Calibration Factory Calibrated
SF47
Remote Room Sensor Calibration Factory Calibrated
SF48
Duct Temperature Sensor Calibration Factory Calibrated
SF50
Fan Status Switch OFF
SF51
Room Sensor 1
SF53
DX Coil Temperature Sensor OFF
SF54
DX Coil Temperature Sensor Calibration Factory Calibrated
SF55
Outdoor-Air Temperature Sensor OFF
SF56
Outdoor-Air Temperature Sensor Calibration Factory Calibrated
SF61
Alarm System Name Network Configured
SF65
Error Code Display OFF
SF67
Alternate Information OFF
SF68
Comfort Trend Demand 0
SF69
Comfort Trend Time Limit 2
SF70
HVAC Usage Meter Data OFF
SF71
Override Usage Meter Data OFF
SF73
Heat Mode Error Set Point 0
SF74
Cool Mode Error Set Point 140
SF75
Device Element Address 0
SF76
Security Level 1
SF77
Device Bus Number 0
SF79
Network Time Broadcast OFF
SF80
Network Time Request OFF
SF81
Receive Network Time ON
SF82
Broadcast Acknowledger OFF
SF83
Global Schedule Broadcast OFF
SF84
Daylight Savings Time ON
SF85
Holiday Schedules 0
SF86
Equipment Priority 7
SF87
Communication Failure Retry Time 10
SF88
Re-Alarm Time 30
SF89
IAQ System ON
SF90
Optimal Start Time Limit 4
SF92
Demand Limit Group Number 0
SF93
Local IAQ Sensor OFF
SF94
IAQ Economizer Delay 10
SF95
IAQ Maximum Space Temperature Reset 2 F
SF96
Humidity Sensor/Filter Switch 0
SF97
Humidity Sensor Calibration Factory Calibrated
SF98
Alarm Routing Control Network Configured (11000000)
SF100
HVAC Meter Enable ON
SF101
Override Meter Enable ON
SF102
HVAC Override Meter Enable ON
SF104
HVAC Override Meter Data OFF
SF106
System Fan Control 0
SF107
System Cool Control 0
SF108
System Heat Control 0
DX —
Direct Expansion
IAQ —
Indoor-Air Quality
LAT —
Leaving-Air Temperature