Carrier 40MAQ Series - Page 58

58
3) Disconnect the
connector for fan motor
from the electronic control
board.
4) Remove the four
fixing screws of the fan
motor.
5) Then remove the fan
motor.
Fan motor connector
3
Electrical
parts
How to remove the
electrical parts.
1) After finish work of
item 1 and item 2, remove
the three connectors for
the compressor and
electrical heaters.
2) Release the
connector of the reactor.
Reactor connector
Four
screws
Compressor
connector and
electrical heater
connector
Two blue wires of four way valve