OG-40MBFQ-04 Specifications subject to change without notice. 9
Selecting the Up-Down Airflow Louver Position
To optimize comfort, the horizontal louver should be adjusted to the
desired position.
When COOLING
Adjust the up-down airflow louver downwards or horizontally (see
Fig. 14).
Fig. 14 — Cooling Airflow (sizes 09-12)
Fig. 15 — Cooling Airflow (sizes 18-58)
When HEATING
Adjust the up−down airflow louver vertically (see Fig. 16).
Fig. 16 — Heating Airflow (sizes 09-12)
Fig. 17 — Heating Airflow (sizes 18-58)
The horizontal up−down airflow louvers can be adjusted by
pressing DIRECT on the remote controller. Press SWING to set
the louvers to a stationary position or to move continuously. The
up−down airflow louver position is stored in the settings, however
it is deactivated when the TURBO or MANUAL settings are set, or
when a power interruption takes place.
Air Direction
Press DIRECT repeatedly to choose one of the up−down airflow
louver positions. Every time DIRECT is pushed, the specific louver
swings 30 degrees.
In the COOLING, DEHUMIDIFICATION, and FAN ONLY
modes, the up−down airflow louver swings in the cooling range.
In the HEATING mode, the louver swings in the heating range.
NOTE: Always use the remote controller to adjust the up−down
airflow louver position, otherwise abnormal operation may occur. If
the horizontal louver is manually adjusted out of its range, power the
unit off and then back on again.
Auto Swing
For automatic horizontal up−down airflow louver swing, push
SWING.
Fig. 18 — Louver Up-Down Swing (Sizes 09-12)
Fig. 19 — Louver Up-Down Swing (sizes 18-58)
To Next Page
Loading...
