Carrier 40VAM-C8FATEE - Page 2

– 1 –
Please read this Installation Manual carefully before installing the Air Conditioner.
• This Manual describes the installation method of the
VRF DX COIL INTERFACE.
• For installation of the air handling unit, follow the Installation Manual attached to the air handling unit. (Field supply)
• For installation of the outdoor unit, follow the Installation Manual attached to the outdoor unit.
• Carrier does not take any responsibility on the local design.
ADOPTION OF R410A REFRIGERANT
This Air Conditioner uses R410A an environmentally friendly refrigerant.
Contents
1. Precautions .................................................................................................................. 3
2. Overview ....................................................................................................................... 7
3. Accessories................................................................................................................ 13
4. Installation .................................................................................................................. 14
Installation Dx-valve kit (Refrigerant pipe) .............................................................. 16
Installation Dx-coil controller (Electrical wiring, DN setting) ................................ 21
5. Test run ....................................................................................................................... 41
6. Trouble shooting ........................................................................................................ 42
Denition of Protective Gear
• When the VRF DX COIL INTERFACE is to be transported, installed, maintained, repaired or removed, wear
protective gloves and “Safety” work clothing.
• In addition to such normal protective gear, wear the protective gear described below when undertaking the special
work detailed in the following table.
• Failure to wear the proper protective gear is dangerous because you will be more susceptible to injury, burns, electric
shocks and other injuries.
Work undertaken Protective gear to wear
All types of work
Protective gloves
“Safety” working clothing
Electrical-related work
Gloves to provide protection from electric shock
Insulating shoes
Clothing to provide protection from electric shock
Work done at heights
(50 cm or more)
Helmets for use in industry
Transportation of heavy
objects
Shoes with additional protective toe cap
Repair Gloves to provide protection for electricians
01_1135451001 EN edit-1.indd 101_1135451001 EN edit-1.indd 1 4/7/2566 BE 09:254/7/2566 BE 09:25