Carrier 40VK S-8S-TST Series - Wireless Remote Controller Functions

4 PARTS NAME OF REMOTE CONTROLLER
■
Wireless remote controller and its
functions
ECO
SLEEP
1
2
4
6
5
15
12
11
8
10
3
7
9
14
13
1
Infrared signal emitter
Transmits a signal to the indoor unit.
2
START/STOP button
Press the button to start operation.
(A receiving beep is heard.)
Press the button again to stop operation.
(A receiving beep is heard.)
If no receiving sound is heard from the indoor unit,
press the button twice.
3
Mode select button ( )
Press this button to select a mode.
Each time you press the button, a mode is selected
in a sequence that goes from A : Auto changeover
control,
: Cool, : Dry, : Fan only, and back
to A. (A receiving beep is heard.)
4
Temperature button ( )
...........The set temperature is increased up to
30°C.
...........The set temperature is dropped down to
17°C. (A receiving beep is heard.)
5
Fan speed button ( )
Press this button to select fan speed.
When you select AUTO, the fan speed is
automatically adjusted according to the room
temperature.
You can also manually select the desired fan speed
from among ve settings.
(LOW
, LOW
+
, MED ,
MED
+
, HIGH )
(A receiving beep is heard.)
6
Auto louver button ( )
Press this button to swing the louver.
(A receiving beep is heard.)
Press the SWING button to stop the louver
swinging.
(A receiving beep is heard.)
7
Set louver button ( )
Press this button to adjust the airow direction.
(A receiving beep is heard.) While this FIX button
is kept depressed, the receiving tone continuously
sounds.
8
Off timer button ( )
Press this button to set the OFF timer.
9
On timer button ( )
Press this button to set the ON timer.
10
Reserve button ( )
Press this button to reserve time settings.
(A receiving beep is heard.)
11
Cancel button ( )
Press this button to cancel ON timer and OFF timer.
(A receiving beep is heard.)
12
High power button ( )
Press this button to start the high power operation.
This function is not operated group control.
13
PRESET button ( )
Press this button to change the operation mode to
the preferred operation mode memorized previously.
To memorize the operation mode, press this button
for at least 3 seconds during the preferred operation
mode.
P is displayed and the operation mode is
memorized.
14
ECO SLEEP button (
ECO
SLEEP
)
Press this button to start the OFF timer operation
that automatically adjusts the room temperature and
the fan speed.
You can select the OFF timer time from four
durations (1, 3, 5 or 9 hours).
During group control operation, the set temperature
and the fan speed are not automatically adjusted.
Only off timer function is activated.
15
QUIET button ( )
Press this button to start quiet operation.
Pressing this button again will restore normal
operation.
- 13 -
01_1130550209_EN.indd 1301_1130550209_EN.indd 13 7/7/2566 BE 16:007/7/2566 BE 16:00