Carrier 40VK S-8S-TST Series - Clock Setting Procedures

5 ADJUSTING CLOCK
Setting the clock
Before you start operating the air conditioner,
set the clock of the remote controller using the
procedures given in this section. The clock panel
on the remote controller will indicate the time
regardless of whether the air conditioner is in use
or not.
■
Initial setting
When batteries are inserted in the remote
controller the clock panel will indicate AM 0:00 and
will ash.
ECO
SLEEP
2
1
1
TIMER or button
Press the TIMER or button to set the current
time.
Each press of the TIMER button changes the time in
one minute steps.
Pressing the TIMER button continually changes the
time in ten minute steps.
2
SET button
Press the SET button.
The current time is indicated and the clock starts.
■
Clock adjusting
ECO
SLEEP
3
2
1
1
CLOCK button
Press the CLOCK by tip of a pencil.
The CLOCK display ashes.
2
TIMER or button
Press the TIMER or button to set the current
time.
Each press of the TIMER button changes the time by
one minute.
Pressing the TIMER button continually changes the
time by ten minutes.
3
SET button
Press the SET button.
The current time is indicated and the clock starts.
- 15 -
01_1130550209_EN.indd 1501_1130550209_EN.indd 15 7/7/2566 BE 16:007/7/2566 BE 16:00