Carrier 40VK S-8S-TST Series - Hints for Economical Operation

EN
CAUTION
• The FIX and SWING buttons will be disabled
when the air conditioner is not in operation
(including when the ON timer is set).
• Do not operate the air conditioner for long hours
with the airow direction set downward during the
cooling or dry operation.
Otherwise, condensation may occur on the
surface of the vertical airow louver and cause
dew dripping.
• Do not move the vertical airow louver manually.
Always use the FIX button. If you move the
louver manually, it may malfunction during
operation.
If the louver malfunctions, stop the air conditioner
once, and restart.
• When the air conditioner is started immediately
after it was stopped, the vertical airow louver
might not move for 10 seconds or so.
• Louver operation is limited when performing
group control. (see page 16)
■
Adjustthehorizontalairow
Preparation
• Take hold of the lever on the horizontal airow
louver and move them to adjust the airow
direction as required.
• You can adjust the airow at the left, and right
locations of the louver.
■
Wireless remote controller A-B
selection
To separate using of remote controller for each
indoor unit in case of 2 air conditioners are
installed nearly.
Remote Control B Setup.
1. Press RESET button on the indoor unit to turn
the air conditioner ON.
2. Point the remote controller at the indoor unit.
3. Push and hold
button on the remote
Controller by the tip of the pencil. “00” will be
shown on the display. (Picture 1)
4. Press during pushing “B” will show
on the display and “00” will disappear and
the air conditioner will turn OFF. The Remote
Control B is memorized. (Picture 2)
NOTE
1. Repeat above step to reset Remote Control to
be A.
2. Remote Control A has not “A” display.
3. Default setting of Remote Control from factory
is A.
3. Le réglage par défaut d’usine de la télécommande est A.
1 2
- 24 -
01_1130550209_EN.indd 2401_1130550209_EN.indd 24 7/7/2566 BE 16:007/7/2566 BE 16:00