Carrier 40VMV054 - Non-Programmable Controller Addressing; Programmable Controller Addressing

RESET
TIMER ON
TIMER OFF
SWING
AIR DIRECTION
CLOCK
OK
SWING
MODE
FAN
AUTO
COOL
DRY
HEAT
FAN
TEMP
SET
CLOCK
SET
HOUR
FAN SPEED
LOCK C/H
6 – AIR DIRECTION
4 – ADJU S T UP
2 – FAN S PEED S ETTING
9 – CLOCK S ETTING
14 – OK (CONFIRM)
10 – TIMER ON
11 – TIMER OFF
1 – MODE S ETTING
3 – ADJU S T DOWN
12 – RE S ET
13 – LOCK
15 – COOL/HEAT
5 – ON/OFF
7 – AIR VERT. S WING
8 – AIR HORIZ. S WING
Fig. 15 — Wireless Remote Controller
(40VM900001)
14
Use a tool to press and hold the LOCK button for at least 10
s
econds, then press to activate. Click or to select an
address and press to send the setting.
To display an indoor unit address, use a tool to press and
hold
the LOCK button for at least 10 seconds, and press to
query the addresses.
Non-Programmable Controller (40VM900002)
When setting an address, connect only one wired controller to
an indoor unit.
Press ROOM TE
MP and SWING simultaneously for 3
seconds. If there is no address for this indoor unit, the display
shows FE# 00 (see Fig. 16) otherwise the display shows the
current address of the indoor unit.
MODE
FAN TEMP. DOWN
OK
TEMP. UP ON/OFF
TIMER
ROOM TEMP.
SWING
#
Fig. 16 — Non-Programmable Controller
(40VM900002) IDU Addressing Menu
Click TEMP. UP or TEMP. DOWN to change 00 to the
desired address as shown in Fig. 17. Then press OK to
confirm
and exit the setting interface.
#
MODE
FAN TEMP. DOWN
TEMP. UP
OK
ON/OFF
TIMER
ROOM TEMP.
SWING
Fig. 17 — Non-Programmable Controller
(40VM900002) Setting IDU Address
Programmable Controller (40VM900003)
When setting an address, connect only one wired controller to
an indoor unit.
1. access parameter settings
as shown in Fig. 18.
MODE
FAN
MENU
TEMP. DOWN
OK
TEMP. UP
BACK
ON/OFF
Fig. 18 — Programmable Controller
(40VM900003) IDU Addressing Menu
2. Press TEMP. UP or TEMP. DOWN to move the cursor
down and choose IDU ADDRESSING, then MENU/OK
to access this setting.