Carrier 42QTD012DS - Remove Fan Motor and Fan Wheel

5
3) Disconnect the fan motor
wire, louver motor wire,
room temperature and
evaporator temperature
wire
, and display board
wire to remove the
electronic control box
4)
Disconnect all the wires
of plugs connected to the
PCB
5)
Remove the PCB from
the fixing pins
3 Remove the
fan motor
and fan
wheel
1) Remove the stickers
stick to the volute shell
Main PCB Fan Capacitor Transformer
Power cord terminal
Control wires for
outdoor unit
Power input
Indoor fan control
Temperature
sensors T1, T2
To Display board
Input/output of
transformer
Swing motor control
Stickers