Need help?Do you have a question about the Carrier 42QG18-C and is the answer not in the manual?
General| Model | 42QG18-C |
|---|---|
| Cooling Capacity | 18000 BTU/h |
| Refrigerant | R410A |
| Indoor Unit Weight | 12 kg |
| Air Flow (High Speed) | 850 m³/h |
| Outdoor Unit Noise Level | 52 dB(A) |
| Type | Split Air Conditioner |
| Power Supply | 220-240V, 50Hz |
| Pipe Connection (Gas/Liquid) | 6.35 mm |
Specifies required clearances around the outdoor unit for optimal operation.
Highlights safety aspects and responsibility for installation.
Alerts to potential hazards and scope of the manual.
Detailed steps for preparing the indoor unit before mounting.
Step-by-step guide for selecting the wall hole location and drilling.
Covers cutting the wall sleeve and installing the wall hang bracket.
Details passing piping through the wall sleeve and mounting the unit.
Steps for preparing the outdoor unit before installation.
Details wall and floor installation methods for the outdoor unit.
General instructions and precautions for connecting refrigerant lines.
More detailed instructions on bending and handling refrigerant pipes.
Details how to calculate and add refrigerant charge.
Detailed steps for cutting and preparing piping ends.
Instructions for mounting flare nuts and flaring the piping.
Steps for connecting refrigerant lines to the indoor unit.
Steps for connecting refrigerant lines to the outdoor unit.
Procedure for purging air and moisture using refrigerant.
Procedure for purging air and moisture using a vacuum pump.
Methods for checking refrigerant joints for leaks.
Wiring between power supply and circuit breaker.
Wiring between indoor, outdoor units, and circuit breaker.
Procedure for conducting cooling mode test runs.
Procedure for conducting heating mode test runs.
To Next Page
