9
7. INSTALLATION ACCESSORIES
7.1 STANDARD INSTALLATION ACCESSORIES Supplied from the factory
DESCREPTION CONFIGURATION QTY USAGE
Battery 1.5 volt size AAA
alkaline type
2 To operate the wireless remote control
Wireless remote control and
Plastic holder for remote
1
To operate the air conditioner
To mount remote control on the wall
Owner manual 1 To illustrate control functions of operation
Installation Manual
1 To illustrate installation instructions.
Insulation Tube.
1
To insulate half unions and Flare nuts after
connecting refrigerant piping lines to the
indoor and outdoor units.
Wall hang bracket
1 For indoor unit installation on the wall.
Self tapping screw 5 x L50
5 For wall hang bracket installation
Tapping Screws
2
For adjustment the gap between indoor
unit and wall.
Drain Elbow
1
Outdoor unit
Condensate drain
7.2 OPTIONAL ACCESSORIES Supplied from the factory as per the requirement
DESCREPTION CONFIGURATION QTY USAGE
Wall support for outdoor unit
1 To mount outdoor unit on the wall
Floor support for outdoor unit
1
To mount outdoor unit on the
ground or floor
Insulated refrigerant piping lines
with flare couplings of lengths
4-6-8-10-12 meter
1
To connect Freon between
outdoor and indoor units and
refrigerant piping lines
Optional air filters
(Carbon air filter + Photo-catalytic
air filter)
Set of 2
To eliminate odor and cigarette
smoke in the room air
respectively.
PTC starting device
1
To start the compressor in
outdoor unit at low voltage down
187V
To Next Page
Loading...
