10
INSTALLATION ACCESSORIES (Cont.)
7.4 OTHER INSTALLATION ACCESSORIES
Not supplied from the factory but must be used in the field to complete installation.
DESCREPTION USAGE
Electrical Connection Cords
To electrically connect the indoor unit, the outdoor unit and circuit
breaker
ـ Wall Sleeve
ـ Wall Cap
ـ Sealer putty
To fill the gap between the wall hole and the lump of refrigerant
piping lines, electrical connection cables and condensate drain line.
ـ Finishing tape PVC film
To tie together the refrigerant piping lines, electrical connection
cables and condensate drain line.
ـ Vinyl tape
To stick pipe insulation.
ـ Drain hose ID 16-17mm
To remove condensate water, from the indoor unit to the outside.
ـ Refrigerant piping lines
To connect Freon R22 between outdoor and indoor units
ـ Pipe insulation
To insulate suction and liquid refrigerant piping lines
- Refrigerant R22
To adjust refrigerant charge for long refrigerant piping lines
(more than 3 meter)
- Refrigerant Oil To be added for long refrigerant piping lines (more than 10 meters)
- Clamps or saddles
To secure the lump of refrigerant piping lines, electrical cables and
condensate drain line
To Next Page
Loading...
