No. Part name Procedure Remarks
Electric parts
1. Detachment
box 1) Perform works of 1 of .
2) Remove the screws of electric parts
box.
3) Draw
s out forward after the electric
box is moved in the direction of the
arrow, and the back of the part electric
part box
is hung on the edge of
the
m
ain body.
2. Attachment
1) It moves in the direction opposite to
ti
me when the electric parts box is
Screws
removed and the claw part in the
interior of the electric part box is
inserted in the hanging part of the
m
ain body.
2) Fix the electric pa
rts box by tightening
wi
th screws. (Ø4 x 10, 2 pcs.)
Control P.C.
1. Detachment
board 1) Perform works of 1 of .
2) Rem
ove the indoor/outdoor connec
ting
w
ire and remote controller wire from
each term
inal block.
3) Remove the connectors which
connected from the control P.C. board
to other parts.
NOTE
First unlock the housing and then
remove the connectors.
2. A
ttachment
CN510 : Louver motor (20P, White)
CN41 : Remote controller terminal block
(2P, Blue)
CN67 : Power supply terminal block
(3P: Black)
CN101 : TC sensor (2P: Black)
CN102 : TCJ sensor (2P, Red)
CN104 : Room temperature
(2P, Yellow)
CN210 : Fan motor (5P, White)
1) Attach the electric parts box and
then perf
orm wiring as original.
4) Unlock
the card edge spacers
(4 positions) in the electric parts box
NOTE
to remove the control P.C. board. Check there is no missing or contact
failure on the connectors.
3
2
3
4
SVM-13050.indb 86SVM-13050.indb 86 6/27/13 10:36 AM6/27/13 10:36 AM
To Next Page
Loading...
