42 WHC/WHE
GB - 6
Hanging panel
Hanging panel with water valve
Hanging panel without water valve
Two types of hanging panel are available: one is for use in
installations with a water valve and the other without.
Hanging panel with water valve
The panel contains:
water shut-off valves with 1/2” female gas threaded fitting for
connection to the water system;
thermo-electric valve piloted by the room thermostat control;
printed circuit for electrical connections;
unit support chain; this permits the unit to be swung downwards
through 90° facilitating installation;
flexible pipes with threaded fitting for the unit hydraulic connection;
control.
The system side hydraulic connections are made inside the
hanging panel, using the 1/2” female gas threaded fitting of the
shut-off valves.
The unit is then connected to the valve group using the flexible
pipes supplied in the hanging panel.
Hanging panel without water valve
The panel contains:
printed circuit for electrical connections;
unit support chain; this permits the unit to be swung downwards
through 90° facilitating installation;
telescopic extensions;
side closing plugs;
control;
The water connections are made using the copper pipes supplied
with the unit and fitted with 3/8” male gas threaded fittings.
If the installation foresees the use of side closing plugs ,
fix them with the screws supplied (ref. a) before hanging the panel
on the wall.
If you use the telescopic extensions make sure that these close
against the wall.
Hanging panel dimensions
Height Width Depth
Volume with
Panel type packaging
mm mm mm m
3
Without water valve 320 900 45 0.031
With water valve 282 / 320 790 45 0.025
Hanging panel weight
Panel weight
Panel weight with
Panel type packaging
kg kg
Without water valve 4.5 5
With water valve 5 5.5
a
To Next Page
Loading...
