Sleep function( ) :
AP function( ):
Press the SET button to enter the function setting, then press SET button or TEMP or TEMP
button to select the desired function. The selected symbol will flash on the display area, press the
OK button to confirm.
To cancel the selected function, just perform the same procedures as above.
Press the SET button to scroll through operation functions as follows:
The SLEEP function is used to decrease
energy use while you sleep (and don t need
the same temperature settings to stay
comfortable). This function can only be
activated via remote control.
Note:
The SLEEP function is not available
in FAN or DRY mode.
,
For the detail, see sleep operation in
Owner’s Manual.
,,
,,
,,
,,
Choose AP mode to do wireless network
configuration. If it doesn’t work by pressing
the SET button. To enter the AP mode,
continuously press the LED
button seven times in 10 seconds.
Sleep( ) Follow Me( ) AP mode( )
[ ]: Only for the unit has AP function
J
J
*
*
or
SET
SET
OK
Follow me function( ) :
The FOLLOW ME function enables the remote
control to measure the temperature at its
current location and send this signal to the
air conditioner every 3 minutes interval.
When using AUTO, COOL or HEAT modes,
measuring ambient temperature from the
remote control(instead of from the indoor
unit itself) will enable the air conditioner to
optimize the temperature around you and
ensure maximum comfort.
If the memory feature is stopped, “ ” OF
displays for 3 seconds on the screen.
While the memory feature is activated,
press the ON/OFF button, shift the mode
or power failure will not cancel the Follow
me function.
NOTE:
Press the SET button to select Follow Me
function.
Pressing the OK button for 3 seconds will
start/stop memory feature of Follow Me
function.
If the memory feature is activated, “ ”
On
displays for 3 seconds on the screen.
To Next Page
Loading...
