45MBDAQ: Installation Instructions
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
31
WIRELESS REMOTE CONTROLLER INSTALLATION
Fig. 61 — Wireless Remote Controller (RG10R(2S))
To attach the mounting bracket:
1. Use the two screws supplied with the wireless remote control to attach
the mounting bracket to the wall in a location selected by the customer
and within operating range.
2. Install the batteries in the remote control.
3. Place the remote control into the remote control mounting bracket.
4. For remote controller operation, refer to the unit’s owner manual.
NOTE: If a wireless remote controller is used, relocate the IR
receiver within the line of sight of the remote location using
the 6 ft. cable included. The factory location of the IR receiver
is inside the remote controller box (see Fig. 62).
Fig. 62 —Control Box
NOTE: For remote control operation, refer to the remote control’s
owners manual.
Wired Remote
Controller 5-Pin Connection
Wired Remote
Controller 4-Pin
Connection
CN40 on PCB Board
IR Receiver
To Next Page
Loading...
