Carrier 48HG024 - Page 14

14
Table 9 — “Service Test” Mode and Submode Directory
Table 10 — “Temperatures” Mode and Submode Directory
SUBMODE
KEYPAD
ENTRY
ITEM DISPLAY ITEM EXPANSION COMMENT
TEST
ON/OFF Field Service Test Mode Use to Enable/Disable Manual Mode
INDP
Test Independent Outputs
ECON XXX Economizer Position Test %
E.PWR ON/OFF Economizer Power Test
E.CAL ON/OFF Calibrate Economizer
PE.1 ON/OFF Power Exhaust 1 Test
PE.2 ON/OFF Power Exhaust 2 Test
ALM ON/OFF Alarm Relay Test
FANS
Te s t Fa n s
IDF ON/OFF Indoor Fan Test
IDFP ON/OFF Indoor Fan Power Test
OFC.1 ON/OFF Outdoor Fan Cntr 1 Test
OFC.2 ON/OFF Outdoor Fan Cntr 2 Test
OFC.3 ON/OFF Outdoor Fan Cntr 3 Test
COOL
Test Cooling
A1 ON/OFF Compressor A1 Test
B1 ON/OFF Compressor B1 Test
C1 ON/OFF Compressor C1 Test
HEAT
Test Heating
HTR.1 ON/OFF Heat Stage 1 Test
HTR.2 ON/OFF Heat Stage 2 Test
SUBMODE
KEYPAD
ENTRY
ITEM DISPLAY ITEM EXPANSION COMMENT
UNIT
Unit Temperatures
SAT XXX.X Supply Air Temperature
OAT XXX.X Outdoor Air Temperature
SPT XXX.X Space Temperature
SPTO X.X Space Temperature Offset
CIRC
Circuit Temperatures
SST.A XXX.X Saturated Suct Temp A Temperature is calculated
SCT.A XXX.X Saturated Cond Temp A
SST.B XXX.X Saturated Suct Temp B Temperature is calculated
SCT.B XXX.X Saturated Cond Temp B
SST.C XXX.X Saturated Suct Temp C Temperature is calculated
SCT.C XXX.X Saturated Cond Temp C
CALB
Calibrate Temperatures
SPT.C XXX.X Space Sensor Calibration
Enter either temperature or
trim but not both
SPT.T XXX.X Space Temperature Trim
Enter either temperature or
trim but not both
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER