138
USB_DIAG
(cont)
TREND VENTILATION On/Off TRNDVENT Yes
TREND GEN INPUTS/OUTPUTS On/Off TRNDIO Yes
Start USB Trending Yes/No TREND_EN
Make Config Backup File Start/Stop DDBCKUP Yes
Backup File is ready
0=IDLE,
1=SUCCESS,
2=FAILURE
BACKUP_R
USB Find Restore File Yes/No BACKFILE Yes
Start Config Restore Start/Stop DDRSTRE Yes
File Error Yes/No FILE_ERR
COOLDIAG
System Demand see Appendix B SYS_DMDT
Operating Sub-Mode see Appendix B SUBMTEXT
Requested IDF Speed 0 to 100 % RQFANSPD
Commanded IDF Speed 0 to 100 % FANSPEED
IDF Commanded RPM rpm FSPD_RPM
OK to Use Free Cooling? Yes/No OKFREECL
Econ Damper Operational Yes/No DAMPGOOD
Dry Bulb Lockout Yes/No DBLOCK Forcible
Enthalpy Lockout Yes/No ENTHLOCK Forcible
Free Cooling Active Yes/No FREECOOL
Unocc Free Cool Active Yes/No UFC_ACT
Free Cooling SAT Setpnt xx.x °F FC_SATSP
Requested Damper Pos 0 to 100 % REQDAMP
Econo Commanded Position 0 to 100 % DAMPCMD Forcible
Ok to use compressors? Yes/No OKMECHCL
Compressor A1 Strikes x A1STRIKE
Compressor A2 Strikes x A2STRIKE
Circuit A Locked Out Yes/No CIRALOCK
Mechanical Cool Active? Yes/No MECHCOOL
Max Allowed Cool Stages 0 to 3 MAXCSTGS Forcible
Number of Cooling Stages 0 to 3 NUMCSTGS
Supply Air Temp Trend xxx.x ^F/min SATTREND
Supply Air Temperature xxx.x °F SAT
Requested Cooling Stages 0 to 3 REQCSTGS
Low Cooling Locked Out Yes/No LC_LOCK
Medium Cooling Lockout Yes/No MC_LOCK
Compressor A1 Timeguard xxx sec TIMGD_A1
Compressor A2 Timeguard xxx sec TIMGD_A2
cmp Loader Timeguard xxx sec TIMG_ALD
Compressor A1 locked out Yes/No CA1_LOCK
Compressor A2 locked out Yes/No CA2_LOCK
Compressor A1 Available Yes/No CA1_AVAL
Compressor A2 Available Yes/No CA2_AVAL
Recent Comp A1 Strike Yes/No A1STKACT
Recent Comp A2 Strike Yes/No A2STKACT
Circuit A Compressor 1 On/Off COMP_A1
Circuit A Compressor 2 On/Off COMP_A2
Circuit A CMP A1 Loader On/Off COMP_ALD
Actual Cool Stage Active x ACTCSTGS
Humidimizer Lockout Temp –20 to 75 °F OATLHUMZ
Req Compr Dehum Stgs 0 to 3 REQDSTGS
High Pressure Override Yes/No HP_OVR
ODF Speed Signal Output1 0 to 1200 rpm ODF1SPD
ODF Speed Signal Output2 0 to 1200 rpm ODF2SPD
ODF Speed Signal Output3 0 to 1200 rpm ODF3SPD
Table T — MAINTENANCE TABLES (cont)
TABLE DISPLAY NAME RANGE UNITS POINT NAME
WRITE
STATUS
APPENDIX D — SYSTEMVU™ CONTROLLER CCN TABLES
To Next Page
Loading...
