CERTIFIED ROOF CURB DIMENSION PRINT
NOTES:
1. Roof curb must be set up for unit being installed.
2. Seal strip must be applied as required for unit being installed.
3. Dimensions in [ ] are in millimeters.
4. Roof curb is made of 16 gage steel.
5. Attach ductwork to curb (flanges of duct rest on curb).
6. Service clearance 4 ft on each side.
7. Direction of airflow.
8. Insulated Panels: 1-in. thick fiberglass 1 lb density.
PART NUMBER CURB
‘‘A’’
(in./mm)
CPRFCURB001A00
FLAT
8 [203]
CPRFCURB002A00 11 [279]
CPRFCURB003A00 14 [356]
7
To Next Page
Loading...
