Carrier 80AWX Series - Page 22

22
English
80AWX- 80AWH
Controller operation
Code
Nr.
Level Variable Name DESCRIPTION
VALUE RANGE
DEFAULT
Min Max
153 Inst.
CURRENT WSP FOR
ZONES
Current water setpoint dened by the system control for the
dierent zones
- - -
Use Days button for Reading the below.
0. Water setpoint for Zone 1
1. Water setpoint for Zone 2
2. Current water setpoint
154 Inst. RUNTIME
Use Days button to read below values. Real values are read
values multiplied by 10.
- - -
0. Compressor run time (hours)
1. Water pump Run time (hours)
2. Backup heater 1 run time (hours)
3. Backup heater 2 run time (hours)
155 Inst. RESET
Use Days button to select the following
0 1 0
0. Compressor run time Reset
0: No Reset
1: Reset
1. Water pump run time reset
0: No Reset
1: Reset
2. Backup heater 1 run time
0: No Reset
1: Reset
3. Backup heater 2 run time
0: No Reset
1: Reset
Software & Matching
156 Inst. CDU CAPACITY Outdoor unit capacity - - -
157 Inst.
NUI SW VERSION
AND RELEASE
User interface Software Version
158 Inst.
GMC SW VERSION
AND RELEASE
System control Software Version & Release
Note:
- cycle power after modifying Installer parameters
- take special care in setting System setup parameters
- parameters referring to system with 2 zone kit are written in gray.